Hi

I am busy flashing my Carambola.
However for the last 30 minutes it has been stuck on this point


[ 12.080000] i2c-gpio i2c-gpio.0: using pins 1 (SDA) and 2 (SCL)
[ 12.280000] Initializing USB Mass Storage driver...
[ 12.280000] usbcore: registered new interface driver usb-storage
[ 12.290000] USB Mass Storage support registered.
[ 16.950000] ramips-wdt: timeout value 60 must be 0 < timeout < 40
[ 20.040000] device eth0.1 entered promiscuous mode
[ 20.050000] device eth0 entered promiscuous mode
[ 20.120000] br-lan: port 1(eth0.1) entering forwarding state
[ 20.120000] br-lan: port 1(eth0.1) entering forwarding state
[ 26.330000] jffs2_scan_eraseblock(): End of filesystem marker found at 0x0
[ 26.360000] jffs2_build_filesystem(): unlocking the mtd device... done.
[ 26.360000] jffs2_build_filesystem(): erasing all blocks after the end marker... done.
[ 73.950000] JFFS2 notice: (1121) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found.

Any advice?

Now I feel stupid, just had to press Enter sorry about that

Please ignore