www.8devices.com
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Carambola Dev-Board maximum current @ 5V
Author |
Message |
phlap
Joined: 24 Jun 2014, 18:32 Posts: 2
|
Hi there,
I am planning to use the prototyping area on the Carambola Dev-Board, where I already spotted some rails for GND, 5V and 3.3V. I assume these pads are the same lines that are wired upon the appr. pins in J5 header area. What current am I safely able to draw from the two 3.3V and 5V lines? I am going to hook up an external GPS receiver which already hosts 3.3V level UART Rx/Tx on an micro USB connector, which also can be used to power the device (and charge the battery, if inserted). It is a Holux GPSlim236 unit, the label says a maximum of 800 mA @ 5V would be needed (I assume for charging). I do not know any real values by now, as I do not have any measurement equipment here by now. But if you say it would not be save to power the GPS device from the prototype area's rails, I will go for an extra supply.
Thanks in advance!
Philipp
|
24 Jun 2014, 18:41 |
|
|
gedass
Joined: 07 Dec 2011, 16:01 Posts: 525 Location: Lithuania
|
Hi, 5V DC/DC converter max current is 3A.Carambola module consume about 1A.
|
24 Jun 2014, 19:20 |
|
|
phlap
Joined: 24 Jun 2014, 18:32 Posts: 2
|
Thank you for this information! So this shall be good enough I think and will keep the job simple.
|
24 Jun 2014, 21:53 |
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|