www.8devices.com
View unanswered posts | View active topics It is currently 28 Mar 2024, 23:02



Reply to topic  [ 2 posts ] 
 restore board not sending udp broadcast for failsafe 
Author Message

Joined: 11 Dec 2014, 08:28
Posts: 1
Greetings,
We had a standard procedure to install our Carambola boards. Suddenly after some months we retook the project and this procedure, while trying to install some programs, finish with a lot of messages like
"unable to install this program that is not for the right architecture"
then we boot and everything doesn't works anymore. We're neither able to here the message to ethernet doing
"tcpdump -Ani eth0 port 4919 and udp -v"
My question is, is it possible to restore those boards? When i'm not able to connect thrugh ethernet, and i neither receive the udp broadcast message telling "press a button for failsafe button"?
Many Thanks


11 Dec 2014, 08:38
Profile

Joined: 11 Jun 2014, 14:45
Posts: 135
I'm not quite sure that I understand the problem. This is how I see it:

* There is a custom service to update multiple Carambola boards
* Previously it was working fine
* You haven't used it for few months
* Recently you did try to use this service to install some packages
* After that your boards don't work

Is this correct?


11 Dec 2014, 11:28
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 2 posts ] 

Who is online

Users browsing this forum: No registered users


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron

Protected by Anti-Spam ACP Powered by phpBB® Forum Software © phpBB Group
Designed by ST Software.