8devices Community https://www.8devices.com/community/ |
|
restore board not sending udp broadcast for failsafe https://www.8devices.com/community/viewtopic.php?f=1&t=847 |
Page 1 of 1 |
Author: | virgiliolino [ 11 Dec 2014, 08:38 ] |
Post subject: | restore board not sending udp broadcast for failsafe |
Greetings, We had a standard procedure to install our Carambola boards. Suddenly after some months we retook the project and this procedure, while trying to install some programs, finish with a lot of messages like "unable to install this program that is not for the right architecture" then we boot and everything doesn't works anymore. We're neither able to here the message to ethernet doing "tcpdump -Ani eth0 port 4919 and udp -v" My question is, is it possible to restore those boards? When i'm not able to connect thrugh ethernet, and i neither receive the udp broadcast message telling "press a button for failsafe button"? Many Thanks |
Author: | Giedrius [ 11 Dec 2014, 11:28 ] |
Post subject: | Re: restore board not sending udp broadcast for failsafe |
I'm not quite sure that I understand the problem. This is how I see it: * There is a custom service to update multiple Carambola boards * Previously it was working fine * You haven't used it for few months * Recently you did try to use this service to install some packages * After that your boards don't work Is this correct? |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |