8devices Community https://www.8devices.com/community/ |
|
Carambola 2 Dev Kit bricked after wireless association? https://www.8devices.com/community/viewtopic.php?f=13&t=641 |
Page 1 of 1 |
Author: | elisiariocouto [ 18 Nov 2013, 17:17 ] |
Post subject: | Carambola 2 Dev Kit bricked after wireless association? |
Hi, I got my hands on a carambola 2 dev kit. I booted it up, telnet, passwd, exited telnet, started an ssh session and everything was fine. I browsed to the LuCI web interface, scanned for a network and tried to associate the board to an AP. The LuCI interface was saying that it was applying the modifications and then it took ages on the waiting screen. I waited for a while and did a reboot (disconnecting the USB cable). After that, I can't access carambola no more and I think it is restarting in a loop. The LED light near the USB port lits, after some 20 seconds it lits again, and so on... Is there any way to access OpenWRT's failsafe mode? I already tried pushing the buttons during the boot (usually failsafe is activated through some kind of button on the devices). No luck :/ Any kind of help would be appreciated. Thanks in advance. Elisiário Couto |
Author: | noblepepper [ 19 Nov 2013, 00:35 ] |
Post subject: | Re: Carambola 2 Dev Kit bricked after wireless association? |
Just start a console through the USB connection and press the reset button and watch for the failsafe prompt. The host computer os will determine details, on windows most use PuTTY, on Linux I like picocom. I believe the data sheet I have has the buttons mislabeled so try both. |
Author: | gedass [ 19 Nov 2013, 05:58 ] |
Post subject: | Re: Carambola 2 Dev Kit bricked after wireless association? |
Or press "enter" on PC terminal. |
Author: | elisiariocouto [ 19 Nov 2013, 13:57 ] |
Post subject: | Re: Carambola 2 Dev Kit bricked after wireless association? |
Ok. I managed to get into failsafe mode through minicom on OS X. I ran "firstboot" and I configured the wireless. After that, I ran "wifi" and same problem :/ sysupgrade -> same problem default wifi configuration -> same problem, boot after reboot. Could it be power issues? |
Author: | gedass [ 19 Nov 2013, 14:12 ] |
Post subject: | Re: Carambola 2 Dev Kit bricked after wireless association? |
Author: | gedass [ 19 Nov 2013, 14:22 ] |
Post subject: | Re: Carambola 2 Dev Kit bricked after wireless association? |
BTW if you need support from our programmers ask here: viewtopic.php?f=3&t=203 because they don't read this forum. |
Author: | elisiariocouto [ 19 Nov 2013, 15:29 ] |
Post subject: | Re: Carambola 2 Dev Kit bricked after wireless association? |
Ok, I discovered that it were power issues :/ Everytime I tried to enable the wireless, the Carambola restarted. I plugged in an external power source and it works Thanks for the help |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |