www.8devices.com
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Run eth0 and eth1 as part of AR9331 hardware switch
Author |
Message |
LaF0rge
Joined: 03 Jan 2014, 21:26 Posts: 7
|
As far as I understand, the AR9331 has a 5-port internal hardware switch.
I would like to run the two physical ethernet ports which are rounted out of the Carambola2 to be handled both by the internal ethernet switch, having only one MAC port of the AR9331 talking to that switch. Does anyone know how to do this?
Why not just configure a software bridge using brctl on Linux? Well, software switching has higher latency and adds software load without any need.
Thanks in advance!
|
03 Jan 2014, 21:41 |
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|