| 8devices Community https://www.8devices.com/community/ |
|
| eth0 not working https://www.8devices.com/community/viewtopic.php?f=13&t=891 |
Page 1 of 1 |
| Author: | prozac [ 12 May 2015, 23:05 ] |
| Post subject: | eth0 not working |
| Author: | Giedrius [ 13 May 2015, 06:48 ] |
| Post subject: | Re: eth0 not working |
Are you using Carambola2 development board or a custom device? |
|
| Author: | prozac [ 13 May 2015, 12:55 ] |
| Post subject: | Re: eth0 not working |
Carambola2 Dev board. It worries my that the phy does not seem to be reporting to ethtool. That would seem to indicate an issue with the AR9331 since they are on chip phys, right? |
|
| Author: | Giedrius [ 14 May 2015, 06:50 ] |
| Post subject: | Re: eth0 not working |
It does look like a hardware problem. If you haven't done anything that might have caused this (change PCB components, apply overvoltages, etc.), please contact info@8devices.com for a replacement. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|