www.8devices.com
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
USB2CAN same message on bus problem
Author |
Message |
glina126
Joined: 15 Jul 2015, 02:08 Posts: 1
|
Hi all,
I am trying to spy on my cars can bus network. I detected the correct baud rate to be 500000bps. When I initialize the device it joins the bus perfectly fine. The messages that i see on the bus are strange though - rather, one single message again and again. The car is on, so the bus should be full of messages. I triple checked the pinout at this point and it is correct. I do get a green light on the device too. Here is a screen shot of what i am seeing as to the messages. It is the exact same thing both on a linux vm and windows.
any ideas what it could be?
Thanks, Damian
Attachments:
File comment: this is what i get when i join the bus
can-bus-msg.png [ 137.69 KiB | Viewed 2081 times ]
|
15 Jul 2015, 02:17 |
|
|
Giedrius
Joined: 11 Jun 2014, 14:45 Posts: 135
|
Did you "detect" the baudrate or did you use the proper one as specified by the manufacturer?
|
16 Jul 2015, 18:06 |
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|