8devices Community https://www.8devices.com/community/ |
|
Unable to pull data from CAN Bus https://www.8devices.com/community/viewtopic.php?f=16&t=998 |
Page 1 of 2 |
Author: | jdg [ 03 Feb 2017, 14:12 ] |
Post subject: | Unable to pull data from CAN Bus |
Hello, I'm currently working on a uni project based around the CAN Bus and I'm having difficulty getting any results. I'm working on a BMW 320d (F32) 2013 and I'm using the USB2CAN and Linux to interface with the bus. Here is how I've setup the rig: Laptop -- USB2CAN -- DB9 to OBDII cable -- OBDII port. Using Linux I run the following commands: sudo ip link set can0 type can bitrate 500000 sudo ip link set up can0 On the actual USB2CAN device the LED light turns constant green I then run cansniffer on can0 however I don't see any data. Here is what I've tried: -Different bitrates (125000, 600000, 700000) -running candump -l any,0:0,#FFFFFFFF Any help would be appreciated, Thanks. |
Author: | timwest [ 04 Feb 2017, 10:41 ] |
Post subject: | Re: Unable to pull data from CAN Bus |
Author: | jdg [ 05 Feb 2017, 13:48 ] |
Post subject: | Re: Unable to pull data from CAN Bus |
Author: | timwest [ 05 Feb 2017, 19:48 ] |
Post subject: | Re: Unable to pull data from CAN Bus |
Author: | gedass [ 05 Feb 2017, 20:45 ] |
Post subject: | Re: Unable to pull data from CAN Bus |
USB2CAN doesn't support any protocol.It is only USB <=> CAN bus frames converter with CANAL type interface for VSCP home automation. |
Author: | timwest [ 05 Feb 2017, 20:49 ] |
Post subject: | Re: Unable to pull data from CAN Bus |
Author: | jdg [ 05 Feb 2017, 22:42 ] |
Post subject: | Re: Unable to pull data from CAN Bus |
No worry tim, thanks anyway! I'll just mess have a play around with it and see if I can get it working. |
Author: | timwest [ 05 Feb 2017, 22:50 ] |
Post subject: | Re: Unable to pull data from CAN Bus |
Author: | gedass [ 06 Feb 2017, 07:15 ] |
Post subject: | Re: Unable to pull data from CAN Bus |
Author: | jdg [ 06 Feb 2017, 09:55 ] |
Post subject: | Re: Unable to pull data from CAN Bus |
Page 1 of 2 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |