www.8devices.com
View unanswered posts | View active topics It is currently 28 Mar 2024, 23:54



Reply to topic  [ 1 post ] 
 Rambutan boot loop 
Author Message

Joined: 18 May 2017, 10:03
Posts: 4
Hi,
after try to update rambutan board following instruction on Getting Started page i'm stuck in a boot loop.
i have build image whit command ./build.sh rambutan and after copy the file /bin/ar71xx/openwrt-8devices-v2.9-ar71xx-nand-rambutan-initramfs-kernel.bin in a USB drive, and rename as 8dev_recovery.bin

have i use wrong bin file? there is no sysupgrade file in folder.

Any help? someone can give me a default image for restart the board?

i am stuck in a boot loop.

Serial output:

U-Boot 2016.01-00030-g2fa4604 (Aug 18 2016 - 17:23:32 +0300)

=========================================
Caraboot v3.1 (QCA9557, NAND) U-Boot
http://www.8devices.com/
-----------------------------------------
DRAM: 128 MiB
NAND: 128 MiB
Net: eth0
Warning: eth0 MAC addresses don't match:
Address in SROM is c4:93:00:07:6e:6b
Address in environment is 00:19:55:66:77:89
, eth1
Warning: eth1 MAC addresses don't match:
Address in SROM is c4:93:00:07:6e:6c
Address in environment is 00:19:55:66:77:89

Hit <ESC> key to stop autoboot: 0
USB0: USB EHCI 1.00
scanning bus 0 for devices... 2 USB Device(s) found
USB1: USB EHCI 1.00
scanning bus 1 for devices... 1 USB Device(s) found
1 Storage Device(s) found
** Unrecognized filesystem type **
** Unrecognized filesystem type **
SCAN partition 1
Partition start 8064 size 30367872 name usbda1
Flashing image 8dev_recovery.bin (3863270 bytes) from usb device 0:1

Flashing image
nand erase.part ubi; nand write 0x80060000 ubi 3af2e6

Erasing at 0x7fe0000 -- 100% complete.000, size 0x7a00000 0
OK

NAND write: device 0 offset 0x600000, size 0x3af2e6
3863270 bytes written: OK

Flashing sucsessful. Remove USB storage with recovery imag
__________________sri____________________
944x BootROM Ver. (asic) 1.0 [Nov 8 2011 13:42:57]
_________________________________________
find_hif: bootstrap = 0x31c50
Nand Flash init
otp_get_nand_table: 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0
ONFI: Control Setting = 0xb44
hdr: [0xbd004000 : 0xbd004000 : 0x2000 : 0x39fbdb14]
nand_load_fw: read 4 pages
nand_load_fw: 0x10000 0x800 0xbd0047f0
nand_load_fw: 0x20000 0x800 0xbd004ff0
nand_load_fw: 0x30000 0x800 0xbd0057f0
f/w 0 read complete, jumping to 0xbd004000
initialize PLL & DDR

sri
Scorpion 1.0
ath_ddr_initial_config(322): (16bit) ddr2 init
... done
*** Warning *** : PCIe WLAN Module not found !!!
*** Warning *** : PCIe WLAN Module not found !!!
... done
fw1: Nand Init
hdr:[0xbd004000 : 0xbd004000 : 0x2000 : 0x39fbdb14]
nand_boot:skip 4 pages
hdr:[0xa0100000 : 0xa0100000 : 0x81000 : 0x5c7a069a]
nand_boot:read 258 pages
f/w 1 read complete, jumping to 0xa0100000


U-Boot 2016.01-00030-g2fa4604 (Aug 18 2016 - 17:23:32 +0300)

=========================================
Caraboot v3.1 (QCA9557, NAND) U-Boot
http://www.8devices.com/
-----------------------------------------
DRAM: 128 MiB
NAND: 128 MiB

forever...

THX


18 May 2017, 10:44
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 1 post ] 

Who is online

Users browsing this forum: No registered users


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron

Protected by Anti-Spam ACP Powered by phpBB® Forum Software © phpBB Group
Designed by ST Software.