Hello! We have the Rambutan-DVK and this kit was initially equipped with firmware (at the NAND flash). Recently we started to use a bare Rambutan modules, but it have no firmware (OpenWrt). How we can to initialize this modules? When we power-on the module, we see next messages from the console port:
________sri__________________ 944x BootROM Ver. (asic) 1.0 [Nov 8 2011 13:42:57] _________________________________ find_hif: bootstrap = 0x31c12 Nand Flash init otp_get_nand_table: 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 ONFI: Control Setting = 0xb44 hdr: [0xbd004000 : 0xbd004000 : 0x2000 : 0x39fbdb14] nand_load_fw: read 4 pages nand_load_fw: 0x10000 0x800 0xbd0047f0 nand_load_fw: 0x20000 0x800 0xbd004ff0 nand_load_fw: 0x30000 0x800 0xbd0057f0 f/w 0 read complete, jumping to 0xbd004000 initialize PLL & DDR
sri Scorpion 1.0 ath_ddr_initial_config(322): (16bit) ddr2 init ... done Warning *** : PCIe WLAN Module not found !!! ... done fw1: Nand Init hdr:[0xbd004000 : 0xbd004000 : 0x2000 : 0x39fbdb14] nand_boot:skip 4 pages hdr:[0xa0100000 : 0xa0100000 : 0x81000 : 0x5c7a069a] nand_boot:read 258 pages Checksum mismatch. 0x5c7a069a != 0x5c7a069c ________sri__________________ 944x BootROM Ver. (asic) 1.0 [Nov 8 2011 13:42:57] _________________________________ find_hif: bootstrap = 0x31c12 Nand Flash init NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c etc
Attachments: |
rambutan.PNG [ 119.82 KiB | Viewed 13526 times ]
|
|