www.8devices.com
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Initializing of the bare Rambutan modules
Author |
Message |
Alex Nozhkin
Joined: 07 Mar 2017, 08:11 Posts: 8
|
Hello! We have the Rambutan-DVK and this kit was initially equipped with firmware (at the NAND flash). Recently we started to use a bare Rambutan modules, but it have no firmware (OpenWrt). How we can to initialize this modules? When we power-on the module, we see next messages from the console port:
________sri__________________ 944x BootROM Ver. (asic) 1.0 [Nov 8 2011 13:42:57] _________________________________ find_hif: bootstrap = 0x31c12 Nand Flash init otp_get_nand_table: 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 ONFI: Control Setting = 0xb44 hdr: [0xbd004000 : 0xbd004000 : 0x2000 : 0x39fbdb14] nand_load_fw: read 4 pages nand_load_fw: 0x10000 0x800 0xbd0047f0 nand_load_fw: 0x20000 0x800 0xbd004ff0 nand_load_fw: 0x30000 0x800 0xbd0057f0 f/w 0 read complete, jumping to 0xbd004000 initialize PLL & DDR
sri Scorpion 1.0 ath_ddr_initial_config(322): (16bit) ddr2 init ... done Warning *** : PCIe WLAN Module not found !!! ... done fw1: Nand Init hdr:[0xbd004000 : 0xbd004000 : 0x2000 : 0x39fbdb14] nand_boot:skip 4 pages hdr:[0xa0100000 : 0xa0100000 : 0x81000 : 0x5c7a069a] nand_boot:read 258 pages Checksum mismatch. 0x5c7a069a != 0x5c7a069c ________sri__________________ 944x BootROM Ver. (asic) 1.0 [Nov 8 2011 13:42:57] _________________________________ find_hif: bootstrap = 0x31c12 Nand Flash init NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c NF Status (0) = 0xff DMA Ctrl (1000) = 0x4c etc
Attachments:
rambutan.PNG [ 119.82 KiB | Viewed 14361 times ]
|
19 Oct 2017, 10:48 |
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|