* [[:|Wiki Home]]
* [[:cheat_sheet|Cheat Sheet]]
* [[:compiling_on_virtualbox|Precompiled virtual tools]]
* [[:carambola_where_to_start|Where to start]]
* [[:carambola_connecting|Connecting to carambola]]
* [[:carambola_using_and_customizing|Using and Customizing]]
* [[:carambola_demo_projects|Demo projects/examples]]
* [[:carambola_hardware|Hardware]]
====== RS-232 level ======
It is best to connect to carambola using standard RS-232 male cable. Just plug cable to carambola, set 115200 8N1 settings without hardware flow control and power up your carambola.
====== TTL 3.3V level ======
However, if you have TTL level USB to serial converter, you should do some soldering.
Remove J9 and J10 jumpers and connect FTDI 3.3V TTL serial to USB cable. J9.1 – RX(input), J10.1 – TX(output). I used FTDI 3.3V USB to serial converter.
{{:carambola_where_to_start_3.jpg?nolink& |}}
====== Software ======
You can use any [[carambola_serial_terminal|terminal]] program you wish to communicate.