I am trying to get my system setup as a simple router setup.
So lan, wan and wifi access point. I just updated to the latest firmware from the virtual machine (openwrt-ramips-rt305x-carambola-squashfs-sysupgrade.bin) but I am having issues getting things configured right.
Where can i look to make sure I have the correct initial configs for the latest version of the firmware?
I can seem to get thing somewhat setup but my wifi client can't see anything even though it connects and gets ip etc.
I tried the setups on the wiki page and they didn't seem to work right.
Are they right particularly the Access Point -
http://www.8devices.com/wiki_carambola/ ... mbola_wifiThanks
Jeremy
This is what I have now after many iterations so its probably not right
/etc/config/network
config interface 'loopback'
option ifname 'lo'
option proto 'static'
option ipaddr '127.0.0.1'
option netmask '255.0.0.0'
config interface 'lan'
option ifname 'eth0.1'
option type 'bridge'
option proto 'dhcp'
option ipaddr '192.168.1.1'
option netmask '255.255.255.0'
config interface 'wan'
option ifname 'eth0.2'
option proto 'dhcp'
/etc/config/wireless
config wifi-device 'radio0'
option type 'mac80211'
option channel '11'
option macaddr 'c4:93:00:11:01:f8'
option hwmode '11ng'
option htmode 'HT20'
list ht_capab 'GF'
list ht_capab 'SHORT-GI-20'
list ht_capab 'SHORT-GI-40'
list ht_capab 'RX-STBC1'
config wifi-iface
option device 'radio0'
option network 'lan'
option mode 'ap'
option ssid 'OpenWrt'
option encryption 'none'