8devices Community https://www.8devices.com/community/ |
|
3G USB dongle wan Interface not displaying on WAN LuCI Page https://www.8devices.com/community/viewtopic.php?f=1&t=271 |
Page 1 of 1 |
Author: | Prashant N [ 30 Nov 2012, 07:23 ] |
Post subject: | 3G USB dongle wan Interface not displaying on WAN LuCI Page |
Hi, I have configured my carambola board for 3G USB dongle wan interface. with Routed AP network set up(Referred OpenWrt home site). Here i used TATA DOCOMO PHOTON 3G USB dongle. I am able to access internet using 3G USB dongle. But problem i am facing is 3G USB dongle wan interface not displaying on WAN LuCI Page. I have gone through the link : http://luci.subsignal.org/trac/ticket/335 But i have already installed package luci-proto-3g and i have file /usr/lib/lua/luci/model/cbi/admin_network/proto_3g.lua on my carambola build directory. Below are the responsible configuration details for 3G USB dongle wan interface with Routed AP network set up. /etc/config/network /******* config interface 'loopback' option ifname 'lo' option proto 'static' option ipaddr '127.0.0.1' option netmask '255.0.0.0' config interface 'lan' option ifname 'eth0.1' option type 'bridge' option proto 'static' option ipaddr '192.168.1.1' option netmask '255.255.255.0' option macaddr 'c4:93:00:11:1b:65' config interface 'wan' option ifname 'ppp0' option device '/dev/ttyUSB3' option apn 'tatadocomo3g' option service 'edge' option proto '3g' config interface 'wifi' option proto 'static' option ipaddr '192.168.2.1' option netmask '255.255.255.0' config switch option name 'rt305x' option reset '1' option enable_vlan '1' config switch_vlan option device 'rt305x' option vlan '1' option ports '1 2 3 4 6t' config switch_vlan option device 'rt305x' option vlan '2' option ports '0 6t' *******/ /etc/config/wireless /****** config wifi-device radio0 option type mac80211 option channel 11 option macaddr c4:93:00:11:1b:60 option hwmode 11ng option htmode HT20 list ht_capab GF list ht_capab SHORT-GI-20 list ht_capab SHORT-GI-40 list ht_capab RX-STBC1 # REMOVE THIS LINE TO ENABLE WIFI: #option disabled 1 config wifi-iface option device radio0 option network wifi option mode ap option ssid OpenWrt option encryption 'psk2' option key 'prashant' ******/ /etc/config/dhcp /**** config dnsmasq option domainneeded 1 option boguspriv 1 option filterwin2k 0 # enable for dial on demand option localise_queries 1 option rebind_protection 1 # disable if upstream must serve RFC1918 addresses option rebind_localhost 1 # enable for RBL checking and similar services #list rebind_domain example.lan # whitelist RFC1918 responses for domains option local '/lan/' option domain 'lan' option expandhosts 1 option nonegcache 0 option authoritative 1 option readethers 1 option leasefile '/tmp/dhcp.leases' option resolvfile '/tmp/resolv.conf.auto' #list server '/mycompany.local/1.2.3.4' #option nonwildcard 1 #list interface br-lan #list notinterface lo #list bogusnxdomain '64.94.110.11' config dhcp lan option interface lan option start 100 option limit 150 option leasetime 12h config dhcp wan option interface wan option ignore 1 config dhcp 'wifi' option interface 'wifi' option start '100' option limit '150' option leasetime '12h' ****/ /etc/config/firewall /******** config defaults option syn_flood 1 option input ACCEPT option output ACCEPT option forward REJECT # Uncomment this line to disable ipv6 rules # option disable_ipv6 1 config zone option name lan option network 'lan' option input ACCEPT option output ACCEPT option forward REJECT config zone option name wan option network 'wan' option input REJECT option output ACCEPT option forward REJECT option masq 1 option mtu_fix 1 config zone option name wifi option input ACCEPT option output ACCEPT option forward REJECT config forwarding option src lan option dest wan config forwarding option src wifi option dest wan config forwarding option src lan option dest wifi config forwarding option src wifi option dest lan # We need to accept udp packets on port 68, # see https://dev.openwrt.org/ticket/4108 config rule option name Allow-DHCP-Renew option src wan option proto udp option dest_port 68 option target ACCEPT option family ipv4 # Allow IPv4 ping config rule option name Allow-Ping option src wan option proto icmp option icmp_type echo-request option family ipv4 option target ACCEPT # Allow DHCPv6 replies # see https://dev.openwrt.org/ticket/10381 config rule option name Allow-DHCPv6 option src wan option proto udp option src_ip fe80::/10 option src_port 547 option dest_ip fe80::/10 option dest_port 546 option family ipv6 option target ACCEPT # Allow essential incoming IPv6 ICMP traffic config rule option name Allow-ICMPv6-Input option src wan option proto icmp list icmp_type echo-request list icmp_type echo-reply list icmp_type destination-unreachable list icmp_type packet-too-big list icmp_type time-exceeded list icmp_type bad-header list icmp_type unknown-header-type list icmp_type router-solicitation list icmp_type neighbour-solicitation list icmp_type router-advertisement list icmp_type neighbour-advertisement option limit 1000/sec option family ipv6 option target ACCEPT # Allow essential forwarded IPv6 ICMP traffic config rule option name Allow-ICMPv6-Forward option src wan option dest * option proto icmp list icmp_type echo-request list icmp_type echo-reply list icmp_type destination-unreachable list icmp_type packet-too-big list icmp_type time-exceeded list icmp_type bad-header list icmp_type unknown-header-type option limit 1000/sec option family ipv6 option target ACCEPT # include a file with users custom iptables rules config include option path /etc/firewall.user ### EXAMPLE CONFIG SECTIONS # do not allow a specific ip to access wan #config rule # option src lan # option src_ip 192.168.45.2 # option dest wan # option proto tcp # option target REJECT # block a specific mac on wan #config rule # option dest wan # option src_mac 00:11:22:33:44:66 # option target REJECT # block incoming ICMP traffic on a zone #config rule # option src lan # option proto ICMP # option target DROP # port redirect port coming in on wan to lan #config redirect # option src wan # option src_dport 80 # option dest lan # option dest_ip 192.168.16.235 # option dest_port 80 # option proto tcp # port redirect of remapped ssh port (22001) on wan #config redirect # option src wan # option src_dport 22001 # option dest lan # option dest_port 22 # option proto tcp # allow IPsec/ESP and ISAKMP passthrough #config rule # option src wan # option dest lan # option protocol esp # option target ACCEPT #config rule # option src wan # option dest lan # option src_port 500 # option dest_port 500 # option proto udp # option target ACCEPT ### FULL CONFIG SECTIONS #config rule # option src lan # option src_ip 192.168.45.2 # option src_mac 00:11:22:33:44:55 # option src_port 80 # option dest wan # option dest_ip 194.25.2.129 # option dest_port 120 # option proto tcp # option target REJECT #config redirect # option src lan # option src_ip 192.168.45.2 # option src_mac 00:11:22:33:44:55 # option src_port 1024 # option src_dport 80 # option dest_ip 194.25.2.129 # option dest_port 120 # option proto tcp ******/ So please guide me on this issue. Thanks, Prashant N |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |