| 8devices Community https://www.8devices.com/community/ |
|
| Minimal hardware https://www.8devices.com/community/viewtopic.php?f=13&t=402 |
Page 1 of 1 |
| Author: | jcw [ 13 May 2013, 17:33 ] |
| Post subject: | Minimal hardware |
| Author: | jcw [ 13 May 2013, 18:47 ] |
| Post subject: | Re: Minimal hardware |
To follow up... By typing "rm /etc/config/wireless" at just the right time, I was able to break the reboot cycle. So my next question is: apart from connecting GND to a few (but not all) pins, a 3.3V power source, 3.3V level RX and TX, and a 2.4 GHz antenna - is anything else needed to make a minimal Carambola 2 setup work, including wireless? (I'm still interested in a better way to recover from the boot failure cycle, the above was really just luck) |
|
| Author: | gedass [ 13 May 2013, 19:11 ] |
| Post subject: | Re: Minimal hardware |
Yes correct.You need GND, 3.3V and antenna. |
|
| Author: | jcw [ 15 May 2013, 22:00 ] |
| Post subject: | Re: Minimal hardware |
I can;t get wireless to work, even just using default network & wireless files and just enabling wireless with the original ap settings causes the C2 to reboot (looks like it happens around the time wireless gets activated). Is there a way to reset the C2 as configured to the original file sets to rule out any mistake? The other option I guess would be to upload a new image through serial, but that looks like a risky job. I don't have wired ethernet, this is a bare C2 board. |
|
| Author: | gedass [ 16 May 2013, 04:04 ] |
| Post subject: | Re: Minimal hardware |
| Author: | adamheinrich [ 16 May 2013, 06:20 ] |
| Post subject: | Re: Minimal hardware |
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|