www.8devices.com
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Author |
Message |
fenyvesi
Joined: 14 Sep 2013, 02:31 Posts: 7
|
I need advices in 2 topics:
1. I configured C2 module WIFI as client. It works, I can use opkg. If I try to connect to the C2 from a browser with its given IP by DHCP, the LUCI does not start. How can I configure it?
2. I need the serial port to connect to a microcontroller. How can I configure a remote console? There is no VNC but I found ser2net. I was not able to use it with the default parameters on ports 2004/3004 (raw/telnet) connections. Shall I configure it somehow? The serial was unconnected.
Thank you.
George
|
16 Sep 2013, 12:49 |
|
|
colin_
Joined: 10 May 2013, 09:54 Posts: 4
|
|
21 Sep 2013, 07:21 |
|
|
fenyvesi
Joined: 14 Sep 2013, 02:31 Posts: 7
|
Thank you Colin, I will try it.
George
|
22 Sep 2013, 10:45 |
|
|
fenyvesi
Joined: 14 Sep 2013, 02:31 Posts: 7
|
Luci works with WIFI on the WAN side, The problem caused by beeing disabled in firewall.
|
28 Sep 2013, 17:58 |
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|