8devices Community https://www.8devices.com/community/ |
|
Can't Get The Console Working https://www.8devices.com/community/viewtopic.php?f=13&t=626 |
Page 1 of 1 |
Author: | grinchdee [ 31 Oct 2013, 16:00 ] |
Post subject: | Can't Get The Console Working |
Just received the Carambola2 development board yesterday and tried to power up. I hooked up the board's mini-usb port to a PC which supports FTDI usb-to-serial, and start a terminal program (FoxTerm) with 115200/8/n/1/no-handshake. The terminal program connected to the USB-to-serial port successfully, but I didn't see any console message dumped to the terminal. Any hint to look for and debug further? |
Author: | hutorny [ 31 Oct 2013, 18:24 ] |
Post subject: | Re: Can't Get The Console Working |
Author: | grinchdee [ 01 Nov 2013, 04:03 ] |
Post subject: | Re: Can't Get The Console Working |
The usb port where the FTDI chip interface with is always 5v. The 2.5v/3.3v cmos signals are between the onboard FTDI chip and AR9331 - i.e. the UART interface, and that should be taken care by the development board design. Is that a correct assumption that when the Carambola2 development board is plugged in to a PC with a proper FTDI driver and correct serial port settings, I should see console message dump to the terminal software? If not, then it is a mal-function board. |
Author: | hutorny [ 01 Nov 2013, 12:22 ] |
Post subject: | Re: Can't Get The Console Working |
Author: | GregWood [ 06 Nov 2013, 21:40 ] |
Post subject: | Re: Can't Get The Console Working |
I had a similar problem. Usually when I started up the carabola 2 dev board I got nothing on the terminal. Not sure why... I found that if I hold down the reset button (S2), get it plugged in, terminal up, etc, then release the power button it works every time. |
Author: | gedass [ 07 Nov 2013, 05:20 ] |
Post subject: | Re: Can't Get The Console Working |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |