www.8devices.com
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Connect USB port to Carambola 2
Author |
Message |
FalconHG
Joined: 10 Jan 2014, 10:45 Posts: 1
|
Hi,
I would like to connect an USB port to a plain Carambola 2 board (USB+, USB-, GND). The board is booting up fine (as I can see on the console), but no connected USB device is detected by the board.
On Carambola 1 I needed to connect UPHY to GND to set USB to host mode, is there an equivalent step required for Carambola 2?
Thanks, --Jack
|
10 Jan 2014, 11:06 |
|
|
gedass
Joined: 07 Dec 2011, 16:01 Posts: 525 Location: Lithuania
|
Hi, for USB client mode: GPIO13 (Led2) to GND. Currently default USB mode is HOST.
|
10 Jan 2014, 12:04 |
|
|
valent
Joined: 18 Nov 2013, 18:44 Posts: 54
|
Thanks! Should U-Boot or OpenWrt kernel show different messages when chaging USB mode?
I have tried pulling GPIO13 to ground and to +3V and I see same kernel messages.
|
10 Jan 2014, 12:41 |
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|