www.8devices.com
|
|
|
Page 1 of 1
|
[ 6 posts ] |
|
Author |
Message |
svenZ
Joined: 08 Jan 2014, 20:37 Posts: 8
|
Got my carambola2 up and running without problems. Before i flash another firmware i want to test if LAN in working.
I had a little linux knowledge, but it's been a while....
I can connect to the board using usb cable & hyperterminal. This works fine. However i can not sem to get the LAN working. with IFCONFIG -a i see all adaptors. (not active)
with ifconfig eth0 192.168.1.150 i assign the ip to eth0 succesful
but then no test works: ping from the board or to board does nothing.
How to test the basic network functioning?
|
16 Jan 2014, 19:55 |
|
|
rop
Joined: 19 Jan 2014, 20:24 Posts: 5
|
|
19 Jan 2014, 21:14 |
|
|
svenZ
Joined: 08 Jan 2014, 20:37 Posts: 8
|
|
20 Jan 2014, 20:52 |
|
|
svenZ
Joined: 08 Jan 2014, 20:37 Posts: 8
|
anyone?
|
10 Feb 2014, 20:08 |
|
|
svenZ
Joined: 08 Jan 2014, 20:37 Posts: 8
|
looking at screenshots above, i figured there was perhaps something wrong with the image. So, with usb-thumbdrive i flashed a new image. Without succes, since carambola2 now only boots untill U-boot.
Within Uboot i can also perform ping, also without succes! Did i receive a faulty board? Or am i missing something?
|
10 Feb 2014, 23:15 |
|
|
gedass
Joined: 07 Dec 2011, 16:01 Posts: 525 Location: Lithuania
|
Hi svenZ,
try to run script "firstboot" and rewrite full image.
|
11 Feb 2014, 05:50 |
|
|
|
Page 1 of 1
|
[ 6 posts ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|