www.8devices.com
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
wifi only acessible if eth0 is plugged in
Author |
Message |
TomCat1
Joined: 14 Apr 2013, 15:42 Posts: 11
|
Hello,
I followed instructions given in OpenWrt and Carambola Wikis to configure my Carambola2 board for Wifi in STA mode. When doing so, and unplugging the ethernet cable connection on eth0 and afterwards reseting the device to rebbot, I cannot access my Carambola2. When then plugging in the ethernet cable, I can access the device on the wireless IP.
I Attached the relevant configs for wireless, network and firewall. in addition there is also a dmesg print given. reading this I would expect to have a functioning connection:
.... [ 26.770000] wlan0: authenticate with 00:18:e7:d4:1b:65 [ 26.780000] wlan0: send auth to 00:18:e7:d4:1b:65 (try 1/3) [ 26.790000] wlan0: authenticated [ 26.800000] wlan0: associate with 00:18:e7:d4:1b:65 (try 1/3) [ 26.800000] wlan0: RX AssocResp from 00:18:e7:d4:1b:65 (capab=0x431 status=0 aid=1) [ 26.810000] wlan0: associated [ 26.810000] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready .... think I anm very close but the last piece of inf is missing....
regs Martin
Attachments:
File comment: configuration of wireless network and firewall. in adittion dmesg print
troublereport.txt [8.07 KiB]
Downloaded 372 times
|
06 Feb 2015, 14:57 |
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|