8devices Community https://www.8devices.com/community/ |
|
Standalone Wifi Settings https://www.8devices.com/community/viewtopic.php?f=13&t=868 |
Page 1 of 1 |
Author: | gsus24 [ 22 Feb 2015, 05:58 ] |
Post subject: | Standalone Wifi Settings |
Good morning, i don´t get the wifi work without dev-board, only carambola2: power, usb and serial to flash Enable wifi, add "option antenna external" and after it always reboot. I am something missing? External Antenna from mobile mark pcb antenna 2,4ghz Thank you |
Author: | Giedrius [ 23 Feb 2015, 07:36 ] |
Post subject: | Re: Standalone Wifi Settings |
Did you follow the reference guide (development module) schematics? It would be easier to answer your question if you posted your schematics and serial output. |
Author: | gsus24 [ 23 Feb 2015, 12:41 ] |
Post subject: | Re: Standalone Wifi Settings |
I think pinout should be right. I get access via terminal and flashed successfully a new image over serial. After enable wifi and add "option antenna external" at etc/config/wireless the board always reboot. Maybe for using external antenna i missing something. Heres the schematic: Power: PIN 49 GND, PIN 50 3V3 input Serial: PIN 43 UART RX, PIN 44 UART TX USB: PIN 20 USB+, PIN 21 USB- U.FL: external Antenna Thanks again for attention Cheers |
Author: | gsus24 [ 23 Feb 2015, 13:44 ] |
Post subject: | Re: Standalone Wifi Settings |
Author: | FPeter [ 23 Feb 2015, 19:28 ] |
Post subject: | Re: Standalone Wifi Settings |
Author: | gsus24 [ 24 Feb 2015, 07:48 ] |
Post subject: | Re: Standalone Wifi Settings |
Thanks Peter, always the same problem didn´t thought about it. But this should be the solution. I use a cheap converter and powered the board with. I will give another try Cheers |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |