[phpBB Debug] PHP Warning: in file [ROOT]/includes/bbcode.php on line 112: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4692: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4694: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4695: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4696: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)

8devices Community https://www.8devices.com/community/
Carambola2 stuck during boot sequence https://www.8devices.com/community/viewtopic.php?f=13&t=916	Page 1 of 1

---

Author:	NathanMingam [ 09 Oct 2015, 16:14 ]
Post subject:	Carambola2 stuck during boot sequence

---

Author:	joky [ 02 May 2016, 10:47 ]
Post subject:	Re: Carambola2 stuck during boot sequence
Hi, did you found any solution? Just soldered my first sample out of a 20-pcb production and, in comparison to the hand made prototype, it fails also during caraboot "net". regards

---

Author:	joky [ 03 May 2016, 05:35 ]
Post subject:	Re: Carambola2 stuck during boot sequence
If anyone sees the same issue: Check your GPIO-pins: Some of those are required to be LOW or HIGH during bootstrap. AFAIK a floating GPIO is ok (internal pull-up/down). In my case I used an external circuit on GPIO17 which pulled-down to GND (instead to pull up to 3V3)

---

Page 1 of 1	All times are UTC
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/