www.8devices.com
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Author |
Message |
joestark
Joined: 01 Jul 2016, 15:26 Posts: 1
|
Hello: Does anybody have any recommendations for washing the Carambola2 module? My application requires the overall PCBA to have a conformal coating. For any conformal coating to adhere properly, the board surface needs to be clean. And as the RF shield is porous, any aqueous cleaning will get into the module.
Essentially, I am looking to use a water-soluble wash with saponifier, followed by a 50degC bake for 2 hours to completely dry the PCBA and the interior of the Carambola2 module. Any advice from the community towards this end would be greatly appreciated.
Thank you all. Joe Stark
|
27 Jan 2017, 19:41 |
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|