View unanswered posts | View active topics It is currently 23 Feb 2018, 08:48

Reply to topic  [ 1 post ] 
 Post-solder wash profile 
Author Message

Joined: 01 Jul 2016, 15:26
Posts: 1
Hello: Does anybody have any recommendations for washing the Carambola2 module? My application requires the overall PCBA to have a conformal coating. For any conformal coating to adhere properly, the board surface needs to be clean. And as the RF shield is porous, any aqueous cleaning will get into the module.

Essentially, I am looking to use a water-soluble wash with saponifier, followed by a 50degC bake for 2 hours to completely dry the PCBA and the interior of the Carambola2 module. Any advice from the community towards this end would be greatly appreciated.

Thank you all.
Joe Stark

27 Jan 2017, 19:41
Display posts from previous:  Sort by  
Reply to topic   [ 1 post ] 

Who is online

Users browsing this forum: No registered users

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  

Protected by Anti-Spam ACP Powered by phpBB® Forum Software © phpBB Group
Designed by ST Software.