| 8devices Community https://www.8devices.com/community/ |
|
| Post-solder wash profile https://www.8devices.com/community/viewtopic.php?f=13&t=994 |
Page 1 of 1 |
| Author: | joestark [ 27 Jan 2017, 19:41 ] |
| Post subject: | Post-solder wash profile |
Hello: Does anybody have any recommendations for washing the Carambola2 module? My application requires the overall PCBA to have a conformal coating. For any conformal coating to adhere properly, the board surface needs to be clean. And as the RF shield is porous, any aqueous cleaning will get into the module. Essentially, I am looking to use a water-soluble wash with saponifier, followed by a 50degC bake for 2 hours to completely dry the PCBA and the interior of the Carambola2 module. Any advice from the community towards this end would be greatly appreciated. Thank you all. Joe Stark |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|