www.8devices.com
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Boot pull up/down resistors
Author |
Message |
jtbeck
Joined: 24 Oct 2017, 19:05 Posts: 13
|
Hi, I am using the Rambutan UART but have to interface to 1.8V logic. I would like to simply use a resistor dividor to reduce the 2.5V transmit signal to the 1.8V however this means I am pulling down on the otherwise pulled up signal. The transmitter pin (19) is a boot H pin. Can you tell me the resistor pull up value in the module? I don't want to put a whole level translator chip in to make the level change if I don't have to. Any other suggestions? Thanks, JB
|
20 Jun 2018, 11:52 |
|
|
gedass
Joined: 07 Dec 2011, 16:01 Posts: 525 Location: Lithuania
|
19 UART_TX (GPIO_10) Bootstrap L via 10K to GND
|
20 Jun 2018, 14:00 |
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|