www.8devices.com
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Author |
Message |
rraasch
Joined: 17 May 2017, 11:02 Posts: 12
|
Hello,
I am developing on the Lima board. Since we need to use i2c, i have used pins 11,12 as the lima-datasheet.pdf has specified. However, we need to use at least 4-5 more GPIOs for production. These will not be needed until userspace starts. Is this a problem?
Also, I am wondering about the UART pins... Can they also be used following the kernel start?
Thanks, Ryan Raasch
|
17 May 2017, 11:07 |
|
|
|
Page 1 of 1
|
[ 1 post ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|