www.8devices.com
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
ETH0 and ETH1 LEDs user addressable?
Author |
Message |
David
Joined: 16 Dec 2011, 14:44 Posts: 105 Location: The Netherlands
|
I am only using Wi-Fi on my Carambola, so the ethernet ports are unused. Can I address the ETH0 and ETH1 LED using software or are they hardwired to the PHYs?
_________________ | |
|
21 Jan 2013, 12:47 |
|
|
DominikS
Joined: 25 Oct 2012, 06:24 Posts: 26
|
The latter. You can only control their behaviour (by accessing some registers, see page 122 of the datasheet for more information), but you can't really toggle or set them afaik. Datasheet: http://www.tracermcc.ru/foto/bender/RT3 ... 8_0902.pdf
|
21 Jan 2013, 15:44 |
|
|
Saulius
Joined: 08 Dec 2011, 09:35 Posts: 138
|
David, according to ralink datasheet, these pins have hardwired functions. You can only change some parameters. Look at attached picture:
Attachments:
2013-01-21_17-56-23.png [ 51.87 KiB | Viewed 2419 times ]
|
21 Jan 2013, 15:57 |
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|