www.8devices.com
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Author |
Message |
colin_
Joined: 10 May 2013, 09:54 Posts: 4
|
Hi all,
I'm going to design a custom carrier board for carambola 1 module.
Here are some questions before starting: - Do you have general guidelines for designing a new carrier board ? - On the official dev board, there is a hole (like 10mm diameter), below the antenna adaptation circuitry. Is this for radio propagation ? - How is the RESET pin connected to the RT3050 ? Is this a Hard or Soft reset ? - Which temperature range does the Carambola 1 does support ? The RT3050 datasheet specified -10/+55. Are there other temperature critical component on the module ?
Thanks for your answers.
Colin
|
10 May 2013, 10:05 |
|
|
gedass
Joined: 07 Dec 2011, 16:01 Posts: 525 Location: Lithuania
|
|
10 May 2013, 11:24 |
|
|
colin_
Joined: 10 May 2013, 09:54 Posts: 4
|
Ok, thanks for your answers
Colin
|
10 May 2013, 12:01 |
|
|
colin_
Joined: 10 May 2013, 09:54 Posts: 4
|
Hi guys,
I would have a more question : Do you have mechanical drawings for carambola dev board ? What's the space between the 2 connectors ?
thks, Colin
|
16 May 2013, 15:06 |
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|